Question: I have a Qnap ts463u-rp data storage array, which contains 4x4TB HDD.

my question here is, is it safe to configure 3x4TB as RAID 5?

because from what I understood, it’s not recommend to configure 12TB storage with RAID 5, because of the Unrecoverable Read Error when rebuilding the Array. is this Right?

Answer: It’s not necessarily bad to configure your RAID 5 array with N TB. What you need to worry about is how much data has to be read AFTER you lose a drive. Depending on the amount and size of the disks in your RAID 5 array, is what calculates your probability of failure for rebuilding the array.

?

What is a URE?

A URE (Unrecoverable Read Error) is when reading the sector of a drive fails, and it cannot be fixed. A URE number simply means that “on average 1 error is detected while reading n bits”. In our scenario, it’s simply running a risk that it will fail to be able to read one of the distributed parities while rebuilding the array.

?

How to find out my probability of failure?

A typical consumer grade hard drive has a bit error rate of 10?. To calculate the probability, we would use the formula Probability = 1-((X-1)/X)^R. X is the number of outcomes, and R is the number of trials. In this case X will be our bit error rate for the drive, 10?. R will be the size of the RAID array after losing a disk. For this case that is 8 TB.

?

Math Time!

First, we want to convert 8 TB to bits. This equals 6.4*10?. Now we can finally calculate the probability of our RAID 5 failing to rebuild after losing a disk.

Probability = 1-((10?-1)/10?)^(6.4*10?) … plug this bad boy into wolfram alpha and you get 0.4727… multiply that by 100 and you have a 47% chance of your RAID 5 array failing to rebuilding in a 3x4TB setup that loses a drive. If you have a 4x4TB setup and you lose one drive, you have a 61% of the disks failing to rebuild.

?

So should I risk it?

The overall conclusion is that if you are using consumer grade hard drives, it can be risky to use large drives with RAID 5. It’s a much different story with enterprise grade drives and hardware. As an example, using a Seagate Enterprise drive with a bit error rate of 10?, recovering a 4x4TB RAID 5 array that loses a drive, has only a 9% chance of failing to rebuild. The consumer grade hard drives has a 61% chance of failure.

In response to a comment by Christoper, I found this sleek RAID rebuild failure chance calculator. It quickly and easily calculates the probability of a URE failing during a RAID 5 or RAID 6 rebuild.

?

RAID rebuild failure chance calculator – created and maintained by magJ