Question: I have 4 HDDs here with me, from 3 different manufacturers, and all of them have the following 4-pin extra interface beside the SATA connector:
Looking on internet, I can see that it exists on all HDD devices, but not on SSDs:
On old IDE devices there was a similar interface used to select operational mode(master/slave), but on SATA it doesn’t makes sense any more…. So, could someone tell me what this interface is intented to do and why it doesn’t exists on SSDs? It is used on any practical situation?
Answer: Those are jumper settings, similar to the IDE drives you mention, but for SATA specific options depending on the drive maker. For example, on this Western Digital support page for mobile drives, it shows two options:
- Reduced Power Spinup – RPS: Used by external hard disks to reduce spinup current and allows it to work over USB interface.
- Spread Spectrum Clocking – SSC: Used when your SATA controller doesn’t support SSC by default.
Also, it doesn’t exists on SSDs because there is no spinup or spread spectrum related to solid-state devices.
@Adrian Cox mentions in the comments below, a different pin function for Seagate drives.